Author Avatar



Share post:

A freshly installed epoxy flooring system, or a freshly installed polyurea system, requires a fair degree of care. Both systems are superbly durable, but a small degree of care will ensure that such polyurea coating systems last for decades.

Clean up Spills Promptly

This is the cardinal rule of floor coating care.

When engineers and technicians test flooring systems, such as epoxy flooring systems, they use a 24-hour immersion test. Testers typically immerse fully cured coatings by using a gauntlet of poisonous solvents and fluids such as brake fluid, natural gas, xylene, MEK, acids, and more. These 24-hour tests reveal which chemicals cause harm to flooring systems. Such testing may reveal “no effect, inch “slight conditioning of film, inch or “film destroyed. inch

That said, while epoxies, polyurethanes, and polyureas are tough as nails, there aren’t many coatings on earth that can survive 24 hours in a bath of brake fluid or MEK. The harshest chemicals that floor coatings will face are MEK, brake fluid, and xylene. On the other hand, nearly all epoxy, advanced two-part commercial polyurethane, and polyurea can easily shrug off all acids, nutrient spirits, oils, and natural gas.

The surest way to ensure the viability and integrity of your floor system is to clean up spills promptly. When spills are not allowed to linger, even the toughest solvent will never get time to scratch your flooring system.

Avoid Scratches and Abrasions

All floor coating systems are governed by abrasions through contact with hard materials. Typically, car automobile won’t scratch your floor, because car automobile are soft. Hard tools, and dirty boots, however, can dull your floor’s surface by creating tiny scratches over time. Never get anything like boxes or cabinets across the floor–carry them or use a hand truck instead.

Refinishing Your Epoxy or Polyurea Floor Coating

Garage coatings can be refinished if necessary–at a cost far less than the original installation. Of course, refinishing should never be necessary within the first 7 to 10 years of your flooring installation. The refinishing process is a snap: A flooring installer can lightly abrade the surface with a walk-behind sanding machine or hand with a sanding block on a stick with medium or medium fine sandpaper. Sanding should abrade the surface just enough so that subsequent coatings will adhere properly, but such sanding should not reach through multiple layers of existing coatings. Naturally, any spills must be cleaned thoroughly.

After the light sanding, installers remove all dust and debris. Thereafter, installers apply a new top coat of clear coating (epoxy, polyurethane, or polyurea, depending on your original installation). A refinish coat in nearly all cases will be a single coat. Remember, the refinish coat is intended to revive the floor’s luster, and one coat usually does the.